Manualshelf

Owner's Manual

ManualsBrandsFreeMotion ManualsHome GymsFreeMotion FMBE90970
21222324252627282930
28
Make sure that all parts are properly tightened each time the weight system is used. Replace any worn parts
immediately. The weight system can be cleaned with a damp cloth and a mild, non-abrasive detergent; do not
use solvents to clean the weight system
.
TIGHTENING THE CABLES
Woven cable, the type of cable used on the weight system, can stretch slightly when it is first used. If there is
slack in the cables before resistance is felt, the cables should be tightened.
See ADDING WEIGHTS TO THE
WEIGHT CARRIAGE in the ADJUSTMENT section of this manual. Add some weights to the weight carriage.
Slack can be removed from the cables several ways:
See the inset drawing. Tighten the M8 Nylon
Locknut (8) that connects the end of the Low Cable
(80) to the “U”-bracket (34).
Remove the M10 Nylon Locknut (37) and the M10 x
48mm Bolt (121) from the two Half Pulley Guards
(91), the Small Cable Trap (93), and the Small Pulley
(74) attached to the “U”-bracket (34). Reattach the
Small Pulley, Small Cable Trap, and Half Pulley
Guards to a lower hole in the “U”-bracket. Make sure
that the Small Cable Trap is in the proper position
and that the Low Cable (80) and Small Pulley
move smoothly.
Remove the M10 Nylon Locknut (37) and the M10 x
48mm Bolt (121) from the two Half Pulley Guards
(91), the Small Cable Trap (93), and the Small Pulley
(74) near the lower end of the two Pulley Plates (92).
Reattach the Small Pulley, Small Cable Trap, and Half
Pulley Guards to a hole closer to the center of the
Pulley Plates.
Make sure that the Small Cable Trap
is in the proper position and that the Low Cable
(80) and Small Pulley move smoothly.
If necessary, adjust the position of the Small Pulley
(74) near the upper end of the Pulley Plates (92) in
the same way.
37
93
92
121
91
91
121
Do not overtighten the cables. If a cable tends to slip off the pulleys often, it may have become twisted.
Remove the cable and re-install it. If a cable needs to be replaced, see ORDERING REPLACEMENT PARTS
on the back cover of this manual.
91
80
93
MAINTENANCE
74
74
80
34
34
91
37
8
74