Owner's Manual

7. SYMPTOM: THE PEDALS SLIP OR GIVE ON THE

POWER STROKE OF EACH REVOLUTION

If the pedals slip on the power stroke, the drive belt

is slipping. You will need to adjust the tension of the

drive belt. Remove the nine 1/4" x 3/4" Button Head

Screws (59) from the Left Side Shield (6), and pivot

the Left Side Shield to the side.

Remove the Right Side Shield (7) in the same way.

Note: For clarity, the left pedal disk is not shown.

Rotate the pedal disk until the Drive Belt (15) is ac-

cessible.

Loosen the four 1/4" x 3/8" Cap Screws (49 [only one

is shown]). Tighten the Generator Tension Bolt (90)

1/4 turn until the Drive Belt (15) stops slipping.

Retighten the four 1/4" x 3/8" Cap Screws, and se-

cure the Left Side Shield with the nine 1/4" x 3/4"

Button Head Screws (59).

Secure the Right Side Shield (7) in the same way.

HOW TO REPLACE THE BATTERY PACK

If you are replacing the Battery Pack (95), see the

paragraph at the top of this page and pivot the left side

shield to the side.

Next, locate the Battery Pack (95). Disconnect the bat-

tery wire from the Lower Battery Wire (77). Cut the

wire ties and discard the Battery Pack according to

federal law.

Reverse this step to attach the new Battery Pack (95).

See the paragraph at the top of this page and reattach

the left side shield.

Wire Ties

Battery

Wire