Owner's Manual

7
HOW TO MOVE AND LEVEL THE RECUMBENT
BIKE
Before moving the recumbent bike, make sure
that the power cord is unplugged. Note: If a CATV
cable is connected to the recumbent bike, it may be
necessary to disconnect the cable if the recumbent
bike will be moved far.
Due to the size and weight of the recumbent bike,
moving it requires two persons. While one person
lifts the indicated end, firmly hold the handlebar and
tip the recumbent bike forward until it rolls on the
front wheels. Carefully move the recumbent bike to
the desired location and then lower it to the level po-
sition.
CAUTION: To reduce the risk of injury, use
extreme caution while moving the recumbent
bike. Do not attempt to move the recumbent bike
over uneven surfaces.
If the recumbent bike rocks slightly during use, turn
the leveling feet under the front and rear of the frame
until the rocking motion is eliminated.
HOW TO ADJUST THE SEAT
To adjust the seat, lift a seat adjustment handle, slide
the seat forward or backward to the desired position,
and then release the seat adjustment handle.
HOW TO CONNECT THE POWER CORD
If the recumbent bike has a Basic console, it can be used with or
without the included power cord.
I
f the recumbent bike has a
Workout TV console, the power cord must be used for the TV to be
operated.
To use the power cord, first plug one end of the power cord into the
jack on the front of the recumbent bike. Plug the other end of the
power cord into an appropriate outlet that is properly installed in ac-
cordance with all local codes and ordinances.
Seat
Adjustment
Handle
HOW TO SET UP THE RECUMBENT BIKE
Lift
Here
Lift
Here
Wheels
Handlebar
Power
Cord
Jack
Leveling
Feet