Owner's Manual

7
HOW TO MOVE AND LEVEL THE UPRIGHT BIKE
Before moving the upright bike, make sure that
the power cord is unplugged. Note: If a CATV
cable is connected to the upright bike, it may be nec-
essary to disconnect the cable if the upright bike will
be moved far.
Due to the size and weight of the upright bike,
moving it requires two persons. While one person
lifts the indicated end, firmly hold the upright and tip
the upright bike forward until it rolls on the front
wheels. Carefully move the upright bike to the de-
sired location and then lower it back to the level posi-
tion. CAUTION: To reduce the risk of injury, use
extreme caution while moving the upright bike.
Do not attempt to move the upright bike over un-
even surfaces.
If the upright bike rocks slightly during use, turn the
leveling feet under the rear or the front stabilizer until
the rocking motion is eliminated.
HOW TO ADJUST THE SEAT
For effective exercise, the seat should be at the proper height. As
you pedal, there should be a slight bend in your knees when the
pedals are in the lowest position. To adjust the height of the seat, lift
the seat adjustment handle, slide the seat upward or downward to
the desired position, and then release the seat adjustment handle.
HOW TO CONNECT THE POWER CORD
If the upright bike has a Basic console, it can be used with or with-
out the included power cord. If the upright bike has a Workout TV
console, the power cord must be used for the TV to operate.
To use the power cord, first plug one end of the power cord into the
jack on the front of the upright bike. Note: If there is a plastic cover
over the jack, remove the cover. Plug the other end of the power
cord into an appropriate outlet that is properly installed in accor-
dance with all local codes and ordinances.
Seat
Adjustment
Handle
Seat
Post
HOW TO SET UP THE UPRIGHT BIKE
Lift
Here
Wheel
Upright
Power
Cord
Jack
Leveling
Feet