Owner's Manual

12
HOW TO SET UP THE CONSOLE
1. Activate the console.
See HOW TO ACTIVATE THE CONSOLE on page
11.
2. Select the User Setup mode.
When you activate the console, the User Setup
mode will be selected automatically.
3. Insert a USB drive into the USB port if desired.
The display will prompt
you to insert a USB
drive into the USB port
on the console. If you
insert a USB drive into
the USB port, your
ride data will be saved to the USB drive in the
RESULTS mode.
If the console detects
a USB drive, a check
mark will appear in the
display.
If the console does not
detect a USB drive, a
cross-out symbol will
appear in the display.
Note: If desired, you can disable the USB port. See
step 3 on page 24.
4. Enter your weight if applicable.
If the console
is used with the
RPM sensor, the
console will prompt
you to enter your
weight. Note: Your
weight is used to
calculate KCAL
values.
Press the
AVG/END or
BACKLIGHT but-
ton to increase
or decrease the
weight value.
Note: If you do
not enter a weight
value, the console
will use the default weight value to calculate KCAL
values.
5. Exit the User Setup mode.
 PresstheSTAGEbuttontoexittheUserSetup
mode and enter the WARM UP mode.
 TheconsolewillautomaticallyexittheUserSetup
mode and enter the WARM UP mode in the follow-
ing conditions:
The console will enter the WARM UP mode after
10 seconds if no buttons are pressed and the ped-
als move at a pedaling cadence greater than 15
RPM.
The console will enter the WARM UP mode imme-
diately if the pedals move at a pedaling cadence
greater than 60 RPM.