Owner's Manual

HOW TO CONFIGURE THE CONSOLE

To select the settings mode, see this page. To pair

the console, see page 21. To change display set-

tings, see page 23. To change system settings,

see page 24. To manage console firmware, see

page 25. To use a bike number, see page 27.

HOW TO USE THE SETTINGS MODE

To select the SETTINGS mode, press and hold the

Backlight and AVG/END buttons for 5 seconds. The

settings menu will appear in the message banner.

To exit the SETTINGS mode, press the AVG/END

button. The word BACK will appear in the message

banner. Then, press the STAGE button. The console

willexittheSETTINGSmode.

You can use the console buttons to navigate through

the menus and change console settings.

The menu options will appear in the message banner.

Press the STAGE button to select a menu option or

enter a setting. Press the Backlight button to move to

the previous menu option. Press the AVG/END button

tomovetothenextmenuoption.

The settings menu contains the following menu

options:

PAIRING—Select this menu option to pair the console

to a power sensor or an RPM sensor.

DISPLAY—Select this menu option to select a unit

of measurement for the console, to change the back-

light duration, and to change the contrast level of the

displays.

SYSTEM—Select this menu option to enable or dis-

able the Auto Pause mode, to enable or disable the

USB port, to view information about console usage,

and to manage the console firmware.

BIKE #—Select this menu option to assign an identi-

fication number to the console. Note: This will ensure

thattheconsoleremainsattachedtothecorrectexer-

cise bike and paired power or RPM sensor.

BACK—Selectthismenuoptiontoexitthesettings

menu.

ToexitamenuortoexittheSETTINGSmode,select

the BACK menu option repeatedly.