Owner's Manual

21
HOW TO PAIR THE CONSOLE
IMPORTANT: The console must be paired to a
power sensor or to an RPM sensor. The console
cannot pair to more than one sensor at a time.
Pairing allows the console to communicate with a
power sensor or an RPM sensor mounted to the
exercisebike.ThepairingprocessusesANT+digital
wireless technology to link the console to the sensor.
The paired console and sensor will have a secure rela-
tionship; they will communicate only with each other
and will not be influenced by other devices in the area.
Itisstronglyrecommendedthateachexercisebikein
a fitness club be numbered for easy identification. To
communicate properly, a paired console and sensor
mustbemountedtothesameexercisebike.Tomake
sure that the correct console stays with the correct
sensorandexercisebike,youcanassignanidentifica-
tion number to the console (see HOW TO USE A BIKE
NUMBER on page 27).
IMPORTANT: Only one console and one sensor
should be paired at a time. During the pairing pro-
cess, other consoles and sensors in the area must
not be in use. This will ensure that the console
pairs to the desired sensor without interference
from other devices.
Tip: It is easier and more convenient to pair the
console and the sensor before you mount the sen-
sor to the exercise bike.
1. Make sure that fresh batteries are installed in
the console and the sensor.
See HOW TO REPLACE BATTERIES on page
28.
2. Locate the pairing button on the power sensor
or the RPM sensor.
Note the location of the pairing button or the pair-
ing button access hole on the power sensor or the
RPM sensor. This button will be used later in the
pairing process.
You will need a paper clip to press the pairing
button on the power sensor. You will also need a
paper clip to press the pairing button on the RPM
sensor if the RPM sensor has been mounted to the
exercisebike.
3. Activate the console and select the PAIRING
menu option.
See HOW TO ACTIVATE THE CONSOLE on page
11.
Then, see HOW TO USE THE SETTINGS MODE
on page 20.
The pairing menu will appear in the message
banner.
Power Sensor
Access
Hole
Pairing
Button
RPM Sensor
Access
Hole