Owner's Manual

28
HOW TO CLEAN THE CONSOLE
To clean the console, use a soft, damp, non-abrasive
cloth. Do not use abrasives or solvents to clean the
console. IMPORTANT: To avoid damage to the con-
sole, keep liquids away from the console and keep
the console out of direct sunlight.
HOW TO REPLACE BATTERIES
When the batteries for the
console, the power sensor,
or the RPM sensor need to
be replaced or recharged,
one of the low battery warn-
ings shown will appear in
the message banner.
IMPORTANT: Replace or
recharge the batteries as
soon as possible when
the low battery warning
appears. If you do not
replace or recharge the
batteries, the console
may shut down or the
sensor may stop trans-
mitting data to the console.
The console can use three C standard alkaline bat-
teries. The power sensor can use two AA standard
alkaline batteries. Standard alkaline batteries have an
extendedshelflife(lowdischargerate)andprovide
good battery life when used.
The console and the power sensor can also use C
and AA NiMH (nickel-metal hydride) rechargeable
batteries. These batteries have longer battery life for
each charge compared to standard alkaline batteries
and can be charged up to five hundred times. These
rechargeable batteries are a good option for high-use
environments, such as fitness clubs. Make sure to use
low discharge rechargeable batteries that have at least
a 2500mAh capacity.
To replace the console batteries, remove the console
from the battery cover and insert the batteries into the
battery compartment. Make sure to orient the bat-
teries as shown by the diagram inside the battery
compartment. Then, reattach the console to the bat-
tery cover.
To replace the power sensor batteries, remove the
battery cover from the power sensor and insert the
batteries into the battery compartment. Make sure to
orient the batteries as shown by the diagram inside
the battery compartment. Then, reattach the battery
cover.
The RPM sensor requires one CR2032 lithium battery.
This is the only battery that can be used with the RPM
sensor.
To replace the RPM sensor battery, remove the
coverandtheRPMsensorfromtheshieldontheexer-
cise bike and insert the battery into the clip on the RPM
sensor. Then, reattach the RPM sensor and the cover
totheexercisebike.
MAINTENANCE