Owner's Manual

9. Make sure that all parts are properly tightened before you use the incline trainer. To protect the floor or

carpet, place a mat beneath the incline trainer.

1. Unplug the power cord. Remove the four Console

Plate Screws (94) and the Basic Console Plate (not

shown). Remove the five #8 x 3/4" Screws (85) from the

back of the Basic Console (not shown), and remove the

Basic Console from the incline trainer. Disconnect all

wires connecting the Basic Console to the incline trainer.

2. Insert the wire harness, the TV cable, and the ground

wire into the bottom of the TV Console Assembly (A) as

you slide the TV Console Assembly onto the bracket on

the Handrail (103). Connect the wire harness, the TV

cable, and the ground wire to the back of the TV

Console Assembly. Make sure to connect the connec-

tors properly.

Align the indicated five holes in the back of the TV

Console Assembly (A) with the five holes in the bracket

on the Handrail (103). Attach the TV Console Assembly

with five #8 x 3/4" Screws (85). Be careful not to pinch

any wires.

Attach the TV Console Plate (118) to the TV Console

Assembly (A) with four Console Plate Screws (94).

118

103

Ground

Wires

TV Cable

Wire

Harness

If you purchase the Workout TV console, follow the steps below to assemble the console.

8. Attach the Front Cover (17) to the Frame (22) with the

two Cover Screws (2) and the four Front Cover Screws

(16).