Owner's Manual
23
8. Enter a program time.
The words ENTER TIME and a time setting of 15
m
inutes will appear in the main display. To change
the length of time that the program will last, press
t
he + and – buttons beside the ENTER button.
Then, press the ENTER button.
9. Press the QUICK START button to start the pro-
gram.
A moment after the button is pressed, the incline
trainer will automatically adjust to the first speed
and incline settings for the program. Hold the
handrails and begin walking.
Each HEART RATE program is divided into 30-
second segments. (The main display will show
both the time remaining in the program and the
time remaining in the current segment of the pro-
gram.) One target heart rate setting is programmed
for each segment. (During the CONSTANT HEART
RATE program, the same target heart rate setting
will be programmed for all segments.)
When only four seconds remain in the first seg-
ment of the program, a series of tones will sound
and then the speed and/or incline of the incline
trainer will change, if needed, to bring your heart
rate closer to the target heart rate setting for the
next segment. The speed and/or incline setting will
flash in the main display to alert you before the
speed and/or incline changes. The program will
c
ontinue until no time remains in the program. The
walking belt will then slow to a stop.
Note: The SPEED and INCLINE buttons will not
function while a HEART RATE program is se-
lected. If your pulse is not detected during the pro-
gram, the letters PLS will flash in the main display
and the speed and incline of the incline trainer may
automatically decrease until your pulse is detected.
If this occurs, see the instructions included with
your chest pulse sensor.
To stop the program at any time, press the STOP
button. HEART RATE programs should not be
stopped temporarily and then restarted. To use a
HEART RATE program again, reselect the pro-
gram and start it at the beginning.
10. Follow your progress with the main display.
See THE MAIN DISPLAY on page 15.
11. When the program is completed, remove the
key.
See step 10 on page 19.