Owner's Manual

HOW TO USE THE MAINTENANCE MODE

The console features a maintenance mode that allows

ou to access information and to view and change var-

ious default settings. Follow the steps below to use the

aintenance mode.

1. Insert the key into the console.

See GETTING STARTED on page 17.

2. Hold down the ENTER button and the CLEAR

button simultaneously for two seconds to se-

lect the maintenance mode.

When the maintenance mode is selected, the

words MAINTENANCE MODE will appear in the

main display. The word HOURS and the total num-

ber of hours that the incline trainer has been used

will then be shown.

3. Press the ENTER button to view the total dis-

tance that the walking belt has moved.

4. Press the ENTER button again and set a maxi-

mum program time.

To set a maximum program time, press the + and

– buttons beside the ENTER button. The maximum

program time can be up to 90 minutes.

5. Press the ENTER button again and set the

delay time for the timeout mode.

ny time that the incline trainer is not used for sev-

eral minutes, the console will enter a timeout mode

nd the words SELECT PROGRAM TO BEGIN will

appear in the main display. To set the number of

seconds before the console will enter the timeout

mode, press the + and – buttons above the

ENTER button. The delay time can be from 15 to

120 seconds.

6. Press the ENTER button again to create the

CUSTOM programs.

The words CUSTOM PROGRAM will appear in the

main display.

You can design up to three CUSTOM programs.

To select a CUSTOM program, press the + and –

buttons beside the ENTER button. When you see

the CUSTOM program you want to design (PRO-

GRAM 1, PROGRAM 2, or PROGRAM 3), press

the ENTER button.

Note: If the CUSTOM program has not yet been

defined, only three rows of indicators will ap-

pear in the matrix.