Owner's Manual

HOW TO DISABLE THE SAFETY KEY

If your INCLINE TRAINER is connected to a 120-volt

ircuit, you can disable the safety key so the INCLINE

TRAINER does not require the use of a key. If your

NCLINE TRAINER is connected to a 220-volt cir-

cuit, you cannot disable the safety key.

1. Remove the key from the console.

Make sure the key is not inserted into the console;

the main display will appear blank.

2. Hold down the ENTER button and the CLEAR

button simultaneously for two seconds to se-

lect the maintenance mode.

When the maintenance mode is selected, the

words MAINTENANCE MODE will appear in the

main display.

3. Press the ENTER button repeatedly to enable

or disable the safety key.

Press the ENTER button repeatedly until the words

SAFETY KEY ENABLED appear in the main dis-

play.

To allow the INCLINE TRAINER to be used without

the safety key, press the + or – button until the

words SAFETY KEY DISABLED appear. Note: The

ext time the key is inserted into the console, the

safety key will automatically be enabled and the

onsole will require the use of the safety key again.

To require the use of the safety key with the con-

sole, press the + or – button above the ENTER

button until the words SAFETY KEY ENABLED ap-

pear in the main display, or insert the key into the

console.

4. Hold down the ENTER button and the CLEAR

button simultaneously for two seconds to exit

the maintenance mode.

To exit the maintenance mode, hold down the

ENTER button and the CLEAR button simultane-

ously for two seconds.