Owner's Manual

7
Assembly requires two persons. Set the incline trainer in a cleared area and remove all packing materials. Do
not dispose of the packing materials until assembly is completed. Assembly can be completed using a 3/8"
h
ex key, a 7/32" hex key, and a Phillips screwdriver.
For help identifying assembly hardware, see the drawings below. Note: If a part is not found in the hardware
kit, check to see if the part has been preattached. To avoid damaging plastic parts, do not use power
tools for assembly.
Console Plate Screw
(94)–4*
Display Mounting Screw
(114)–5*
*These Screws are included only with the Workout TV console INCLINE TRAINER.
1/2" Star
Washer (124)–4
Side Base Bolt (95)–4
Top Base Bolt (96)–4
ASSEMBLY
1. Place the Uprights (93) near the front of the Base Frame
(56) as shown.
Connect the indicated wires on the right side of the in-
cline trainer. See the inset drawing. The connectors
should slide together easily and snap into place. If
they do not, turn one connector and try again. IF THE
CONNECTORS ARE NOT INSERTED PROPERLY,
THE CONSOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON.
Insert the excess wire into the indicated hole in the
Upright (93).
93
56
Wires
1
Hole
RIGHT
LEFT