Owner's Manual

5. With the help of a second person, pivot the console as-

sembly to the position shown. Be careful to avoid

pinching your hands or the wires.

Align the Handrail Bolts (102) with the holes in the tops

f the Uprights (93). Start all four Handrail Bolts, and

then firmly tighten them.

Console

ssembly

102

6. After the incline trainer is placed in the location where it

will be used (see HOW TO MOVE THE INCLINE

TRAINER on page 11), make sure that both Rear

Leveling Feet (38) and the Base Pads (not shown) rest

firmly on the floor. If the incline trainer rocks even

slightly, turn the right Rear Leveling Foot clockwise or

counterclockwise until the rocking motion is eliminated.

Note: The Power Cord Bracket (64) must be attached

at all times.

7. Remove the two Cover Screws (2) and the four Front

Cover Screws (16) from the Frame (22).