Owner's Manual

20
If desired, adjust the volume by pressing the Vol
increase and decrease buttons on the console.
To pause the workout, touch one of the menu but-
tons or press the Stop button on the console. To
continue the workout, touch the Resume button or
the Start button. To end the workout session, touch
the End Workout button.
6. Measure your heart rate if desired.
Note: If you use the handgrip heart rate moni-
tor and the optional chest heart rate monitor at
the same time, the console will not display your
heart rate accurately.
Before using
the hand-
grip heart
rate monitor,
remove the
sheets of plas-
tic from the
metal contacts.
In addition,
make sure that
your hands are
clean.
To measure your heart rate, stand on the foot
rails and hold the contacts with your palms for
approximately ten seconds; avoid moving your
hands. When your pulse is detected, your heart
rate will be shown. For the most accurate heart
rate reading, continue to hold the contacts for
about 15 seconds.
7. Turn on the fan if desired.
The fan features multiple speed settings and an
auto mode. When the auto mode is selected, the
speed of the fan will automatically increase and
decrease as the speed of the walking belt increases
and decreases.
Press the Fan increase button to increase the fan
speed. Note: If you press the Fan increase button
once while the fan is on its maximum speed set-
ting, the auto fan mode will be selected. Press the
Fan decrease button repeatedly to decrease the
fan speed or to turn off the fan.
8. When you are finished exercising, remove the
key from the console.
Step onto the walking platform and touch the home
button or the back button on the screen or press
the Stop button on the console. A workout sum-
mary will appear on the screen. After you view the
workout summary, touch the Finish button to return
to the main menu. You may also be able to either
save or publish your results using one of the op-
tions on the screen. Then, remove the key from the
console and put it in a secure place.
When you are finished using the incline trainer,
press the power switch into the off position and un-
plug the power cord. IMPORTANT: If you do not
do this, the incline trainer’s electrical compo-
nents may wear prematurely.
Contacts