Owner's Manual

Regular maintenance is necessary for optimal performance and long life of the incline trainer. Please

read and follow all instructions below. If the incline trainer is not maintained as described, components

may wear excessively, the incline trainer may be damaged, and the warranty will be voided. If you have

questions about maintenance, please see the back cover of this manual. CAUTION: Make sure to remove the

key and unplug the power cord before performing any maintenance procedures.

WEEKLY MAINTENANCE

1. Unplug the power cord. Inspect and properly tighten all external parts of the incline trainer.

2. Apply a mild multi-purpose cleaner to a 100 percent cotton cloth and remove any dust and grime from the

handrails, uprights, foot rails, frame, and motor hood. In addition, wipe the walking platform along the sides of

the walking belt. Do not use cleaners under the walking belt. Apply a small amount of mild multi-purpose

cleaner to a 100 percent cotton cloth and wipe the console and the screens. Do not spray cleaner directly

onto the incline trainer or use ammonia or acid-based cleaners.

3. Make sure that the walking belt is centered and properly tightened. If it is centered and runs smoothly, do not

make any adjustments. If the walking belt needs to be adjusted, see pages 33 and 34.

MONTHLY MAINTENANCE

1. Unplug the power cord. Remove the 3/8" x 1 1/4" Screws

(37) attaching the Motor Hood (75), and lift off the Motor

Hood.

2. Using a hand-held vacuum, clean the area under the Motor

Hood (not shown). Be careful to avoid touching any com-

ponents. Check the Drive Motor Belt (82) for wear and

cracks. If the motor belt needs to be replaced, please see the

back cover of this manual.

3. Plug in the power cord and insert the key into the console. Press the START button. Be careful to avoid

injury; keep your hands away from moving parts and make sure that your clothes cannot become

caught in moving parts. While the walking belt is moving, check the incline trainer for unusual noises or

odors. If any of these problems exists, please see the back cover of this manual. Remove the key and un-

plug the power cord. Reattach the Motor Hood (75) with the 3/8" x 1 1/4" Screws (37).

4. Hold a clean, dry towel between the walking platform and the walking belt. Pull the towel from side to side

along the length of the walking platform. Rotate the walking belt and repeat this step until the entire walking

belt has been cleaned.

VMTL

PREVENTIVE MAINTENANCE