Owner's Manual

34
SYMPTOM: The walking belt is off-center or slips
when walked on
a. If the walking belt has shifted to the right:
Remove the key and unplug the power cord.
Using a 7/32" hex key, turn the roller adjustment
screws in the directions shown, 1/4 of a turn each.
Be careful not to overtighten the walking belt.
Then, plug in the power cord, insert the key, and
use the incline trainer for a few minutes. Repeat
until the walking belt is centered.
b. If the walking belt has shifted to the left:
Remove the key and unplug the power cord.
Using a 7/32" hex key, turn the roller adjustment
screws in the directions shown, 1/4 of a turn each.
Be careful not to overtighten the walking belt.
Then, plug in the power cord, insert the key, and
use the incline trainer for a few minutes. Repeat
until the walking belt is centered.
c. If the walking belt slips when walked on:
Remove the key and unplug the power cord.
Using a 7/32" hex key, turn both roller adjustment
screws clockwise 1/4 of a turn. When the walking
belt is properly tightened, you should be able to
lift each side of the walking belt 2.5 to 5 cm (1 to
2 in.) off the walking platform. The center of the
walking belt should just touch the walking platform.
Make sure to keep the walking belt centered. Then,
plug in the power cord, insert the key, and run
the incline trainer for a few minutes. Repeat until
the walking belt is properly tightened. Note: As
you tighten the roller adjustment screws, the front
roller will move. If the front roller stops moving,
do not further tighten the roller adjustment
screws; please see the back cover of this
manual.
SYMPTOM: The walking belt stops or the incline
cannot be adjusted even though the console re-
mains lit
a. This indicates that a controller error may have
occurred. To correct the problem, turn the power
switch off, wait 5 seconds, and then turn the power
switch back on.
SYMPTOM: The incline system does not function
properly or the incline system does not appear to
be at the incline level shown in the display
a. Calibrate the incline system (see step 4 on page
26).
b. If the incline system still does not function properly,
please see the back cover of this manual.
a
Right
b
Left
c