Owner's Manual

9
Next, press the VOLUME + or – button.
The console will begin scanning all TV
channels in your area. Each time the
console scans a new channel, a beep
will be heard and the channel number
will appear on-screen.
If no broadcast signal is detected on a
channel, the channel will be skipped; if a
signal is detected, the channel will be
stored in memory.
Note: While the console is scanning
channels, you can manually skip
unwanted channels or store desired
channels. To manually skip a channel,
press the CHANNEL + button within two
seconds after the channel number
appears on-screen. To manually store a
channel, press the VOLUME + button
within two seconds after the channel
number appears on-screen.
The scanning process will continue until
the console scans the highest channel.
The console will then automatically exit
the configuration mode.
Note: To manually add or delete chan-
nels at any time, select the configuration
mode and initiate the channel-scanning
function again.
Exit the configuration mode.
If you did not initiate the channel scan-
ning function, hold down the TV ONLY
button and the VOLUME + button for
about two seconds to exit the configura-
tion mode.
5
Channel:
Volume:
Channel:
Volume: