Owner's Manual

Before moving the INCLINE TRAINER, unplug the

power cord. Note: It may be necessary to disconnect a

CATV cable and a network wire from the INCLINE

TRAINER, depending on how far the INCLINE

TRAINER will be moved.

Due to the size and weight of the INCLINE TRAINER,

moving it requires two or three persons. Hold the

metal frame firmly in the location shown at the right.

CAUTION: To decrease the possibility of damage to

the INCLINE TRAINER or of injury, do not lift the

frame by the plastic front cover.

Carefully roll the IN-

CLINE TRAINER on the wheels to the desired location

and then lower it back to the level position. CAUTION: To

reduce the risk of injury, use extreme caution while

moving the INCLINE TRAINER. Do not attempt to

move the INCLINE TRAINER over uneven surfaces.

Frame

Front

Cover

Wheels

8. Make sure that all parts are properly tightened before you use the INCLINE TRAINER. To protect the

floor or carpet, place a mat beneath the INCLINE TRAINER.

5. After the INCLINE TRAINER is placed in the location

here it will be used (see HOW TO MOVE THE IN-

CLINE TRAINER below), make sure that both Rear

Feet (38) and the Base Pads (not shown) rest firmly on

the floor. If the INCLINE TRAINER rocks even slightly,

turn the right Rear Foot clockwise or counterclockwise

ntil the rocking motion is eliminated.

Note: The Power Cord Bracket (64) must be at-

tached at all times.

6. Remove the two Cover Screws (2) and the four Front

Cover Screws (16) from the Frame (22).

7. Attach the Front Cover (17) to the Frame (22) with the

two Cover Screws (2) and the four Front Cover Screws

(16).

HOW TO MOVE THE INCLINE TRAINER