Owner's Manual

4. SYMPTOM: THE WALKING BELT IS OFF-CENTER OR SLIPS WHEN WALKED ON

f the walking belt has shifted to the right: Remove the

key and unplug the power cord. Using a 7/32” hex key,

urn the roller adjustment bolts in the directions shown, 1/4

of a turn each. Be careful not to overtighten the walking

belt. Then, plug in the power cord, insert the key, and use

the INCLINE TRAINER for a few minutes. Repeat until the

walking belt is centered.

If the walking belt has shifted to the left: Remove the

key and unplug the power cord. Using a 7/32” hex key,

turn the roller adjustment bolts in the directions shown, 1/4

of a turn each. Be careful not to overtighten the walking

belt. Then, plug in the power cord, insert the key, and use

the INCLINE TRAINER for a few minutes. Repeat until the

walking belt is centered.

If the walking belt slips when walked on: Remove the

key and unplug the power cord. Using a 7/32” hex key,

turn both roller adjustment bolts clockwise 1/4 of a turn.

When the walking belt is properly tightened, you should be

able to lift each side of the walking belt 2.5 to 5 cm (1 to 2

in.) off the walking platform. The center of the walking belt

should just touch the walking platform. Make sure to keep

the walking belt centered. Then, plug in the power cord, in-

sert the key, and run the INCLINE TRAINER for a few min-

utes. Repeat until the walking belt is properly tightened.

Note: As you tighten the roller adjustment bolts, the front

roller will move. If the front roller stops moving, do not

further tighten the roller adjustment bolts; see HOW

TO CONTACT CUSTOMER CARE on page 2.

5. SYMPTOM: THE WALKING BELT STOPS OR THE INCLINE CANNOT BE ADJUSTED EVEN THOUGH

THE CONSOLE REMAINS LIT

a. This indicates that a controller error may have occurred. To correct the problem, turn the power switch off,

wait 5 seconds and then turn the power switch back on.

6. SYMPTOM: THE INCLINE SYSTEM DOES NOT FUNCTION PROPERLY OR THE INCLINE SYSTEM DOES

NOT APPEAR TO BE AT THE INCLINE LEVEL SHOWN IN THE MAIN DISPLAY

The incline system may need to be calibrated. To initiate the calibration routine, turn the power switch off,

wait 5 seconds and then turn the power switch back on. During the calibration routine, the INCLINE TRAINER

will automatically travel to the lowest incline level and then return to level.

b. If the incline system still does not function properly, see HOW TO CONTACT CUSTOMER CARE on page 2.

Right

Left