Owner's Manual

8
3. Cut the tie holding the wire to the right Upright (93). Plug
the wire in the right Upright and the wire in the console
assembly into a Wire Adapter (130) (see the inset draw-
ing).
Make sure to insert the connectors properly; the
connectors should slide easily and snap into place.
If
a connector does not slide easily and snap into place,
turn it and then insert it. IF THE CONNECTORS ARE
NOT INSERTED PROPERLY, THE CONSOLE MAY BE
DAMAGED WHEN THE POWER IS TURNED ON. If
there is a TV Cable, connect it as well. Then, insert the
wires down into the right Upright.
Align the Handrail Bolts (102) with the holes in the tops
of the Uprights (93). Be careful to avoid pinching your
hands or the wires. Start all four Handrail Bolts, and
then firmly tighten them.
If your INCLINE TRAINER has a Workout TV console, continue to step 4. If your INCLINE TRAINER has a
Basic console, skip to step 5.
2
. Finger tighten two Top Base Bolts (96) with two 1/2” Star
Washers (124) through the top of the bracket near the
right Upright (93) and into the Base Frame (56).
R
epeat this step on the left side of the INCLINE
TRAINER.
Then, tighten the Top Base Bolts (96) and the Side Base
Bolts (95) on both sides.
95
9
3
56
9
6
124
2
4. Insert the wire harness, the TV cable, and the ground
wire into the bottom of the TV Console Assembly (A) as
you slide the TV Console Assembly onto the bracket on
the Handrail (103). Connect the wire harness, the TV
cable, and the ground wire to the back of the TV
Console Assembly.
Make sure to connect the con
-
nectors properly.
Align the indicated five holes in the back of the TV
Console Assembly (A) with the five holes in the bracket
on the Handrail (103). Attach the TV Console Assembly
with five Display Mounting Screws (114). Be careful
not to pinch any wires.
Attach the Console Plate (118) to the TV Console
Assembly (A) with four Console Plate Screws (94).
118
94
103
114
Console
Assembly
102
130
Wires
102
93
3
Ground
Wires
A
TV Cable
Wire
Harness
4