Owner's Manual

37
M
ost problems can be solved by following the simple steps below. Find the symptom that applies, and
follow the steps listed. If further assistance is needed, please see the back cover of this manual.
1. SYMPTOM: THE POWER DOES NOT TURN ON
a. Make sure that the power cord is plugged into a properly grounded outlet. (See page 12.)
b. Make sure that the key is inserted into the console.
c. Check the on/off circuit breaker located on the treadmill near the power
cord. Make sure that the on/off circuit breaker is switched to the “on” posi-
tion.
2. SYMPTOM: THE POWER TURNS OFF DURING USE
a. Check the on/off circuit breaker located on the treadmill near the power cord. (See drawing 1. c. above.)
Make sure that the on/off circuit breaker is switched to the “on” position.
b. Make sure that the power cord is plugged in.
c. Remove the key from the console. Reinsert the key into the console.
d. Check the walking belt and the walking platform for excessive wear. Replace the walking belt or the walk-
ing platform if necessary.
e. If the power still turns off during use, please see the back cover of this manual.
3. SYMPTOM: THE WALKING BELT SLOWS WHEN WALKED ON
a. If the walking belt is overtightened, performance
may decrease and the walking belt may be dam-
aged. If the walking belt is properly tightened, you
should be able to lift each side of the walking belt
2.5 to 5 cm (1 to 2 in.) off the walking platform. If ad-
justments need to be made, first remove the key
and unplug the power cord. Using a 7/32" hex
key, turn both roller adjustment bolts counterclock-
wise 1/4 of a turn. Then, plug in the power cord, in-
sert the key, and use the treadmill for a few minutes.
Be careful to keep the walking belt centered. Repeat
until the walking belt is properly tightened. Note: To
tighten the walking belt, see step 4. c. on page 38.
b. If the walking belt still slows when walked on, please see the back cover of this manual.
“On”
Position
c
Roller Adjustment Bolts
2.5 to 5 cm
a
TROUBLESHOOTING