Owner's Manual

3. Finger tighten two Top Base Bolts (96) with two 1/2" Star

Washers (124) through the top of the bracket near the

right Upright (93) and into the Base Frame (56); do not

tighten the Top Base Bolts yet.

Repeat this step on the left side of the treadmill.

Then, tighten the Top Base Bolts (96) and the Side Base

Bolts (95) on both sides.

124

4. Locate the Bolt (B) on the top of each Upright (93). With

the help of a second person, set the console assembly

onto the top of the Uprights. Make sure that the Bolts

are inserted into the indicated holes in the bottom of

the console assembly (only one side is shown). Be

careful not to pinch any wires. Pull up on the Handrail

(103) and carefully tip the console assembly forward so

that you can see the indicated wires. Make sure the

console assembly is held securely by the Bolts.

Connect the wire in the right Upright (93) and the wire in

the console assembly. See the inset drawing. The

connectors should slide together easily and snap

into place. If they do not, turn one connector and try

again. IF THE CONNECTORS ARE NOT INSERTED

PROPERLY, THE CONSOLE MAY BE DAMAGED

WHEN THE POWER IS TURNED ON. If there is a TV

Cable, connect the TV Cable in the console assembly to

the TV Cable in the right Upright. Then, insert the wires

down into the right Upright.

Wires

Hole

Console

Assembly

TV Cables

103

2. Slide the Uprights (93) onto the Base Frame (56), and

align the holes in the Uprights with the holes in the Base

Frame. Be careful to avoid pinching the wires. Finger

ighten two Side Base Bolts (95) through the bracket

near the right Upright and into the Base Frame; do not

ighten the Side Base Bolts yet.

Repeat this step on the left side of the treadmill;

there are no wires on the left side.