Owner's Manual

Before moving the treadmill, unplug the power

cord. Note: It may be necessary to disconnect a CATV

cable and a network wire from the treadmill, depending

on how far the treadmill will be moved.

Due to the size and weight of the treadmill, moving

it requires two or three persons. Hold the metal

frame firmly in the location shown at the right.

CAUTION: To decrease the possibility of damage to

the treadmill or of injury, do not lift the frame by the

plastic front cover.

Carefully roll the treadmill on the

wheels to the desired location and then lower it back to

the level position. CAUTION: To reduce the risk of in-

jury, use extreme caution while moving the tread-

mill. Do not attempt to move the treadmill over un-

even surfaces.

Frame

Front

Cover

Wheels

8. Make sure that all parts are properly tightened before you use the treadmill. To protect the floor or car-

pet, place a mat beneath the treadmill.

5. After the treadmill is placed in the location where it will

e used (see HOW TO MOVE THE TREADMILL

below), make sure that both Rear Feet (38) and the

Base Pads (not shown) rest firmly on the floor. If the

treadmill rocks even slightly, turn the right Rear Foot

clockwise or counterclockwise until the rocking motion

s eliminated.

Note: The Power Cord Bracket (64) must be at-

tached at all times.

6. Remove the two Cover Screws (2) and the four Front

Cover Screws (16) from the Frame (22).

7. Attach the Front Cover (17) to the Frame (22) with the

two Cover Screws (2) and four Front Cover Screws

(16).

HOW TO MOVE THE TREADMILL