Owner's Manual

8
3. Cut the tie holding the wires to the right Upright (93).
Connect the wires in the console assembly to the wires
in the Upright.
Make sure to connect the connectors
properly (see the inset drawing); the connectors
should slide together easily and snap into place.
If
the connectors do not slide together easily and snap into
place, turn one connector and try again. IF THE CON-
NECTORS ARE NOT CONNECTED PROPERLY, THE
CONSOLE MAY BE DAMAGED WHEN THE POWER
IS TURNED ON. If there is a TV Cable, connect it. Then,
insert the wires down into the right Upright.
Align the Handrail Bolts (102) with the holes in the tops
of the Uprights (93). Be careful to avoid pinching your
hands or the wires. Start all four Handrail Bolts, and
then firmly tighten them.
If your treadmill has a Workout TV console, go to step 4. If your treadmill has a Basic console, go to step 5.
2
. Finger tighten two Top Base Bolts (96) through the top of
the bracket near the right Upright (93) and into the Base
Frame (56).
R
epeat this step on the left side.
Then, tighten the Top Base Bolts (96) and the Side Base
Bolts (95) on both sides.
Console
Assembly
102
Wires
102
93
3
95
93
56
96
2
4. Hold the TV Console (A) near the bracket on the
Handrail (103). Connect the wire and the TV cable to
the back of the TV Console (A). Make sure to con-
nect the connectors properly.
Align the five holes in the back of the TV Console (A)
with the five holes in the bracket on the Handrail (103).
Attach the TV Console Back (B) to the TV Console with
five Long Display Mounting Screws (114).
Be careful
not to pinch any wires. Then, tighten four Short
Display Mounting Screws (113) and the two Audio
Housing Screws (C) into the TV Console Back.
Attach the Console Plate (118) with four Console Plate
Screws (94).
114
A
Wire
TV Cable
118
B
C
94
103
113
4