Owner's Manual

ssembly requires two persons

Set the treadmill in a cleared area and remove all packing materials. Do not

dispose of the packing materials until assembly is completed. Assembly can be completed using a 3//8” hex

key.

For help identifying assembly hardware, see the drawings below. Note: If a part is not found in the part bags,

heck to see if the part has been preattached.

1. Slide the Uprights (93) to a position near the front of the

Base Frame (56) as shown.

Connect the wires in the right Upright (93) to the wires in

the Base Frame (56). Make sure to connect the con-

nectors properly (see the inset drawing); the connec-

tors should slide together easily and snap into place.

If the connectors do not slide together easily and snap

into place, turn one connector and try again. IF THE

CONNECTORS ARE NOT CONNECTED PROPERLY,

THE CONSOLE MAY BE DAMAGED WHEN THE

POWER IS TURNED ON.

Next, slide the Uprights (93) onto the Base Frame (56),

and align the holes in the Uprights with the holes in the

Base Frame. Be careful to avoid pinching the wires.

Finger tighten two Side Base Bolts (95) through the

bracket near the right Upright and into the Base Frame;

do not tighten the Side Base Bolts yet.

Repeat this step on the left side. Note: There are no

wires on the left side.

Wires

3 1/2” Bolt (64)–2

Long Display Mounting

Screw (114)–5

Short Display Mounting

Screw (113)–4

Console Plate Screw

(94)–4

Audio Housing Screw

(C)–2

These screws are included only with

the Workout TV console treadmill.

Side Base Bolt (95)–4

Top Base Bolt (96)–4

ASSEMBLY