Owner's Manual

7
4. Make sure that all parts of the vibration platform are properly tightened.
2. Set the Platform (3) on the Base (16).
Tip: Have a second person hold the
H
andlebar (10) and tip the Base (16) to the
left and to the right while you perform the
f
ollowing actions:
Insert the four Sound Absorbers (51) into the
four Isolators (7).
Next, insert the four Flanged Bolts (6) on the
underside of the Platform (3) through the holes
in the Base (16).
Then, tighten a Suction Foot (17) onto each
Flanged Bolt (6).
3. Note: For clarity, the Platform (3) is not
shown in this drawing.
Tip: It may be helpful to tip the vibration
platform onto its side for this step.
Tighten a Suction Foot (17) onto the M10 x
35mm Hex Bolt (38) in the underside of the
Base (16).
3
16
51
2
10
17
17
6
6
7
16
3
17
38