Owner's Manual

6. Remove the indicated 3/8" x 3/8" Shoulder Bolt

(52) from the Support Arm (7).

Make sure that the 3/8" Nylon Washer (50) is

etween the Support Arm (7) and the Adjustment

Arm (10), and that the 3/8" Bushing (51) is

pressed into the Support Arm. Attach the Support

Arm to the Adjustment Arm with the 3/8" x 3/8"

Shoulder Bolt (52).

7. Make sure that all parts are properly tightened.

This section explains how to adjust the strength equipment for exercising. Make sure all parts are properly tight-

ened each time the strength equipment is used. Replace any worn parts immediately.

ADDING WEIGHTS TO THE WEIGHT ARM

To add resistance to your workout, slide an equal

amount of weight (not included) onto each Weight Bar

(13). Make sure that the weights are pushed against

the Bumper Rings (37).

ADJUSTING THE BACKREST

To change the angle of the Backrest (14), pull the

Knob (24) out and move the Backrest to the desired

position. Reengage the Knob into the Backrest

Bracket (not shown).

ADJUSTING THE FRAME SUPPORT

To allow the Foot Plate (5) to descend, push it up and

lift the Adjustment Arm (10) so that the Frame Support

(8) pivots toward the Seat (15). When you are finished

exercising, return the Frame Support to its position

under the Foot Plate Frame (4).

ADJUSTMENTS

WARNING: Do not place more

than 450 pounds on each Weight Bar (13).

Always place an equal amount of weight on

each Weight Bar.