Instructions / Assembly

18
When the console is con-
nected to a wireless network,
the wireless symbol in the
display will show the strength
of your wireless signal. Four
arcs indicate full signal strength. If the wireless
symbol is flashing, the console is not connected to
a wireless network.
Change the volume level
of the console by pressing
the volume increase and
decrease buttons.
5. Measure your heart rate if desired.
If there are sheets
of plastic on the
metal contacts
on the handgrip
heart rate moni-
tor, remove the
plastic. To mea-
sure your heart
rate, hold the
handgrip heart rate monitor with your palms resting
against the contacts. Avoid moving your hands
or gripping the contacts tightly.
When your pulse is detected, one or two dashes
will appear, and then your heart rate will be shown.
For the most accurate heart rate reading, hold
the contacts for at least 15 seconds.
If the display does not show your heart rate, make
sure that your hands are positioned as described.
Be careful not to move your hands excessively or
to squeeze the contacts tightly. For optimal perfor-
mance, clean the contacts using a soft cloth; never
use alcohol, abrasives, or chemicals to clean
the contacts.
6. Turn on the fan if desired.
The fan has several speed
settings. Press the fan
increase and decrease but-
tons repeatedly to select a
fan speed or to turn off the
fan.
Note: If the pedals do not move for about thirty
seconds, the fan will turn off automatically.
7. When you are finished exercising, unplug the
power cord.
If the pedals do not move for several seconds, a
tone will sound and the console will pause.
If the pedals do not move for several minutes and
the buttons are not pressed, the console will turn
off and the display will be reset.
When you are finished exercising, press the power
switch to the off position and unplug the power
cord. IMPORTANT: If you do not do this, the
electrical components on the elliptical may
wear prematurely.
Contacts