Instructions / Assembly

HOW TO ADJUST THE DRIVE BELT

If the pedals slip while you are pedaling, even while

the resistance is adjusted to the highest level, the drive

belt may need to be adjusted. To adjust the drive belt,

first unplug the power cord.

Next, use a flat screwdriver and pry off the Shield

Cover (56) and slide it upward.

Then, remove the four M4 x 16mm Screws (not shown)

from the upper and lower ends of the Rear Shield (75),

and remove the Rear Shield.

Then, look between the Shields (73, 74) and locate the

M8 Locknut (102). Tighten the Locknut until the Drive

Belt (113) is tight.

When you have properly adjusted the drive belt, reat-

tach the rear shield and press the shield cover onto the

rear shield.

113

102

FCC INFORMATION

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the equipment off

and on, try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

FCC CAUTION: To assure continued compliance, use only shielded interface cables when connecting to

computer or peripheral devices. Changes or modifications not expressly approved by the party respon-

sible for compliance could void the user’s authority to operate this equipment.