Instructions / Assembly

11. With the help of a second person, hold the con-

sole assembly (I) near the Handrails (74).

See the inset drawing. Connect the Upright

Wire (83) to the console wire (K). The connec-

tors should slide together easily and snap

into place. If they do not, turn one connector

and try again. IF YOU DO NOT CONNECT THE

CONNECTORS PROPERLY, THE CONSOLE

MAY BECOME DAMAGED WHEN YOU TURN

ON THE POWER.

Next, connect the two fan wires (G, L). Then,

remove any wire ties from the Upright Wire (83)

and the fan wires.

Connect the two coaxial cables on the other

side (not shown). Insert the excess cable

and fan wire into the Right and Left Uprights

(84, 91).

12. Attach the console assembly (I) to the Handrails

(74) with four 5/16" x 2" Screws (2) and four

5/16" Star Washers (8); start all four Screws,

and then tighten them. Be careful not to

pinch the wires and cables (M).

Insert the wires and cables (M) upward into the

console assembly (I).

13. Identify the #8 x 3/4" Truss Head Screws (24).

IMPORTANT: Do not confuse the #8 x 3/4"

Truss Head Screws with the #8 x 3/4" Screws

(5). The #8 x 3/4" Truss Head Screws have

flatter heads.

Start four #8 x 3/4" Truss Head Screws (24) into

the Pulse Crossbar (80), and then tighten them;

do not overtighten the Truss Head Screws.