Owner's Manual

9
5. Have a second person hold the Console (101)
near the handrail assembly.
C
onnect the Upright Wire (111) and the handrail
wires to the console wires. Make sure that the
c
onsole wire and the handrail wire that you are
connecting have connectors that are the same
size. See the lower drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and
then try again. IF THE CONNECTORS ARE
NOT CONNECTED PROPERLY, THE CON-
SOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON.
Insert the excess wires downward into the
Upright Cover (80).
Set the Console (101) on the handrail assembly.
Be careful not to pinch any wires.
80
101
111
5
Console
Wires
111
Console
Wire
Handrail
Assembly
Handrail
Wires
Handrail
Wire
6. Align the holes in the Console (101) with the
holes in the handrail assembly and the holes in
the Upright (not shown). Attach the Console and
the handrail assembly to the Upright with two
3/8" x 3 1/4" Patch Screws (1) and two 3/8" Star
Washers (2). Do not tighten the Patch Screws
yet.
Note: It may be helpful to press the indicated
bracket against the Upright (81) and to press
downward on the Console (101) to align the
holes.
6
101
Handrail
Assembly
1
2
81
Bracket