Installation & Assembly

132"
18"
6"
11" Between
Mallet Poles
and Chimes
18"
Between
Chimes
8
8
4
2
5
7
1
3
6
3/8" Drill Diameter
to a Depth of 4"
DETAIL A
SCALE 1 : 6
10
9
Parts List:
Step 1: Determine your layout. Spacing between Chimes
and Mallet Poles must be maintained per the
diagram shown to allow the Mallets to reach each
Chime. Although the Chimes can be laid out in a
variety of styles such as an arc, wave, or straight-line;
we suggest one of the following layout orders:
#6, #4, Mallet Pole, #2, #1, #3, Mallet Pole, #5, #7
or
#1, #2, Mallet Pole, #3, #4, #5, Mallet Pole, #6, #7
Step 2: Determine installation location. Verify concrete
footing is a minimum of 132" long x 18" wide x 6" thick,
depending on the layout you go with. If the concrete
pad is at an angle, steel washers are required to act
as shims (Shims not provided). If there is not already
an existing pad, approximately (23) 80lb. bags will
be needed. Allow concrete to cure per concrete
manufacturers guidelines.
Step 3: With two people place the Chimes and Mallet Poles
individually onto the concrete pad and mark the
center of the holes on the surface mount plates.
After you have made your marks, set aside the Chimes
and Mallet poles in order to drill for anchor holes.
With a hammer or rotary drill, drill through concrete
at marked locations. Drill to a minimum depth of 4".
A 3/8" masonry drill bit will be needed.
Step 4: Place the Chimes and Mallet Poles back over the
drilled out holes. Insert provided anchor bolts into
aligned holes. Position anchor nut so that it is flush
with the top of the bolt. Pound anchor bolts into the
hole until the anchor washer is flush with the surface
mount base. Tighten anchor bolts until they are snug.
Cover remaining bolt sections with provided nut caps.
ITEM NO. DESCRIPTION QTY.
1 Contrabass Chimes - Surface Mount Chime Assembly 1 1
2 Contrabass Chimes - Surface Mount Chime Assembly 2 1
3 Contrabass Chimes - Surface Mount Chime Assembly 3 1
4 Contrabass Chimes - Surface Mount Chime Assembly 4 1
5 Contrabass Chimes - Surface Mount Chime Assembly 5 1
6 Contrabass Chimes - Surface Mount Chime Assembly 6 1
7 Contrabass Chimes - Surface Mount Chime Assembly 7 1
8 Contrabass Chimes - Surface Mount Mallet Pole Assembly 2
9 3/8"-16 Wedge Expansion Anchor, 3.75"lg. SS 27
10 35/64" Hex Nut Cap 27
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN THIS
DRAWING IS THE SOLE PROPERTY OF
FREENOTES HARMONY PARK. ANY
REPRODUCTION IN PART OR AS A
WHOLE WITHOUT THE WRITTEN
PERMISSION OF FREENOTES HARMONY
PARK IS PROHIBITED.
FREENOTES HARMONY PARK
194 BODO DRIVE, UNIT F
DURANGO CO 81303
TEL: [phone]
FAX: [phone]
WWW.FREENOTESHARMONYPARK.COM
SHEET 3 OF 3
TITLE:
SCALE: 1:24
REVISION: A
DATE: 2/7/2018
DWG. NO.
Surface Mount Installation with Parts List
CCH-INSTALL