Installation & Assembly

(3" or Less)
(9" or Greater)
6" Thick
Concrete Pad
Finished Height
(Concrete to
Top of Drum)
DETAIL A
SCALE 1 : 4
7
8
6
Parts List:
Step 1: Arrange Drums in desired location and pattern. Drums can be laid out in any configuration desirable,
but must be installed less than 3" or greater than 9" apart.
WARNING: Between 3" and 9" there lies a chance for a child's head to get stuck.
(Reference: US Consumer Product Safety Commission, Public Playground Safety Handbook)
Step 2: Once you have decided your layout, replace drums with the provided
Anchor Discs. Mark holes on the concrete through the (3) holes on all of
the Anchor Discs. Set aside Discs, drill 1/4" holes 2" into concrete at
marked locations. A
1/4" masonry drill bit will be needed. Contractor
to provide a concrete slab that will perform under local soil and weather
conditions. (If anchoring to a material other than concrete, fasteners to
be provided by the customer)
Step 3: Place the Anchor Discs back over the drilled out holes. Insert provided
anchor bolts into aligned holes. Position anchor nut so that it is flush with
the top of the bolt. Pound anchor bolts into the hole until the anchor
washer is flush with the post base. Tighten anchor bolts until they are snug.
Step 4: Install the Drums over the Anchor Discs. Predrill (4) 1/8" holes in a 90
cross pattern, 1" up from the bottom of the drum. Drill through both Drum
and Anchor Disc. When predrilling holes, make sure they clear the
previously installed anchor bolts, and that there is clearance for the
2" screws to be installed without interfering with the other drums. Secure
Drums to Discs with the provided #10 Butten Head Screws and Driver.
Step 5: Check for sufficient clearance around instruments.
A 36" clearance is recommended around the the
entire Drum arrangement for wheelchair accessibility,
however this is not required for proper function.
Drums may also be installed next to a wall or in a
variety of different configurations.
Step 6: Remove plastic film from drum caps if applicable.
ITEM NO. DESCRIPTION QTY. NORMAL FINISHED HEIGHT TODDLER FINISHED HEIGHT
1
15" Surface Mount Tuned Drum 1 37" 29"
2
12" Surface Mount Tuned Drum 1 35" 27.5"
3
10" Surface Mount Tuned Drum 1 33" 26"
4
8" Surface Mount Tuned Drum 1 31" 24.5"
5
6" Surface Mount Tuned Drum 1 29" 23"
6 Surface Mount Anchor Disc 5 - -
7
1/4 x 3.25" Anchor Bolt, SS 15 - -
8 #10 Button Head Screw, 2"lg. SS, T25 tamp 20 - -
9 Security Driver 1 - -
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN THIS
DRAWING IS THE SOLE PROPERTY OF
FREENOTES HARMONY PARK. ANY
REPRODUCTION IN PART OR AS A
WHOLE WITHOUT THE WRITTEN
PERMISSION OF FREENOTES HARMONY
PARK IS PROHIBITED.
FREENOTES HARMONY PARK
194 BODO DRIVE, UNIT F
DURANGO CO 81303
TEL: [phone]
FAX: [phone]
WWW.FREENOTESHARMONYPARK.COM
SHEET 3 OF 3
TITLE:
SCALE: 1:24
REVISION: A
DATE: 2/9/2018
DWG. NO.
Surface Mount Installation with Parts List
TD-INSTALL