User's Manual

Table Of Contents

Safety Information

1320x-QE128EVB Reference Manual, Rev. 0.0

1-2 Freescale Semiconductor

1.1.3 47 C.F.R. Sec.15.203

An intentional radiator shall be designed to ensure that no antenna other than that furnished by the

responsible party shall be used with the device. The use of a permanently attached antenna or of an

antenna that uses a unique coupling to the intentional radiator shall be considered sufficient to comply with

the provisions of this Section. The manufacturer may design the unit so that a broken antenna can be

replaced by the user, but the use of a standard antenna jack or electrical connector is prohibited. This

requirement does not apply to carrier current devices or to devices operated under the provisions of

Sections 15.211, 15.213, 15.217, 15.219, or 15.221. Further, this requirement does not apply to intentional

radiators that must be professionally installed, such as perimeter protection systems and some field

disturbance sensors, or to other intentional radiators which, in accordance with Section 15.31(d), must be

measured at the installation site. However, the installer shall be responsible for ensuring that the proper

antenna is employed so that the limits in this Part are not exceeded.

1.2 Disposal Instructions

This product may be subject to special disposal requirements. For product disposal instructions, refer to