User's Manual
Table Of Contents
- About This Book
- Chapter 1 Safety Information
- Chapter 2 1322x Network Node Module Overview and Description
- Chapter 3 System Overview and Functional Block Descriptions
- Chapter 4 Interface Locations and Pinouts
- 4.1 Overview
- 4.2 Power Management
- 4.3 RF Circuitry
- 4.4 USB Connector (“B” Receptacle)
- 4.5 LEDs, Switch, Buttons and Joystick
- 4.6 LCD Connector
- 4.7 Debug/Development Connectors
- 4.8 Audio Subsystem Connections
- 4.9 GPIO Connector
- 4.10 FLASH Memory Recovery Jumpers and Erase
- 4.11 ADC Voltage References
- 4.12 Jumper Selection
- Chapter 5 Schematic, Board Layout, and Bill of Material
1322x Network Node Reference Manual, Rev. 1.1
Freescale Semiconductor 4-1
Chapter 4
Interface Locations and Pinouts
This chapter provides a description of the interface location and pinout of the 1322x Network Node PCB.
4.1 Overview
This chapter provides the locations (as shown in Figure 4-1) and descriptions of switches, jumpers, and
connectors on the 1322x Network Node PCB. Users should reference the figures in the subsequent sections
while moving through this chapter and reference the circuit board schematic in Chapter 5, “Schematic,
Board Layout, and Bill of Material”, for additional information.
Figure 4-1. Network Node PCB Top View
F
Tact SwitchesOn-Off Switch
JTAG ConnectorGPIO Connector
USB
DC
Supply
Joystick
RF ConnectorLCD Display
Audio
Connector
Buzzer