User's Manual
Table Of Contents
- About This Book
- Chapter 1 Safety Information
- Chapter 2 1322x Network Node Module Overview and Description
- Chapter 3 System Overview and Functional Block Descriptions
- Chapter 4 Interface Locations and Pinouts
- 4.1 Overview
- 4.2 Power Management
- 4.3 RF Circuitry
- 4.4 USB Connector (“B” Receptacle)
- 4.5 LEDs, Switch, Buttons and Joystick
- 4.6 LCD Connector
- 4.7 Debug/Development Connectors
- 4.8 Audio Subsystem Connections
- 4.9 GPIO Connector
- 4.10 FLASH Memory Recovery Jumpers and Erase
- 4.11 ADC Voltage References
- 4.12 Jumper Selection
- Chapter 5 Schematic, Board Layout, and Bill of Material
Interface Locations and Pinouts
1322x Network Node Reference Manual, Rev. 1.1
Freescale Semiconductor 4-3
4.3 RF Circuitry
The external antenna is connected via the provided SMA connector (J7).
NOTE
Only the provided Antenova
®
antenna (model Titanus) should be used with
this module. This RF design has been certified with this antenna.
Figure 4-2. Antenova
®
Titanus Model Antenna
4.4 USB Connector (“B” Receptacle)
The USB connector is designated as J6. Figure 4-3 shows the connector pinout.
Figure 4-3. USB Connector Pinout