User's Manual
Table Of Contents
- About This Book
- Chapter 1 Safety Information
- Chapter 2 1322x Network Node Module Overview and Description
- Chapter 3 System Overview and Functional Block Descriptions
- Chapter 4 Interface Locations and Pinouts
- 4.1 Overview
- 4.2 Power Management
- 4.3 RF Circuitry
- 4.4 USB Connector (“B” Receptacle)
- 4.5 LEDs, Switch, Buttons and Joystick
- 4.6 LCD Connector
- 4.7 Debug/Development Connectors
- 4.8 Audio Subsystem Connections
- 4.9 GPIO Connector
- 4.10 FLASH Memory Recovery Jumpers and Erase
- 4.11 ADC Voltage References
- 4.12 Jumper Selection
- Chapter 5 Schematic, Board Layout, and Bill of Material
Interface Locations and Pinouts
1322x Network Node Reference Manual, Rev. 1.1
Freescale Semiconductor 4-5
4.6 LCD Connector
The LCD module is connected to the main circuit board via a 30-conductor flat flex cable (FFC) with 0.5
mm spacing. The main board connector is an FFC, Right Angle Dip, zero insertion force (ZIF), 30 pin
connector (J13).
NOTE
The LCD connector is a ZIF unit. Be sure to release the connector before
trying to connect or disconnect the FFC to the LCD.
4.7 Debug/Development Connectors
4.7.1 ARM JTAG Interface Connector
The MC1322x supports connection to a subset of the defined ARM JTAG connector. The JTAG interface
is a standard 2.54mm/0.1inch spacing, 20-pin debug interface (J1). The 20-pin connector is clearly
separated from the GPIO pin header (J2) and located at the rear side of the module. The 20-pin connector
has Pin 1 marking for correct plug-in of the development cable.
Table shows the device pins that are connected to the associated JTAG header pin outs if the JTAG
connector is used.
Table 4-3. ARM JTAG 20-Pin Connector Assignments (J1)
Name
1
1
NC means No Connect.
Pin # Pin # Name
VCC 1 2 VCC
NC
2
2
MC1322x does not support separate JATG reset TRST.
34GND
TDI 5 6 GND
TMS 7 8 GND
TCK 9 10 GND
RTCK 11 12 GND
TDO 13 14 GND
RESET
3
3
VCC through a 100k-ohm pullup.
15 16 GND
NC 17 18 GND
NC 19 20 GND