User manual

ATM AAL2
MPC8260 PowerQUICC II Family Reference Manual, Rev. 2
32-30 Freescale Semiconductor
Table 32-9 describes the CPS switch RxQD fields.
32.4.4.6 SWITCH Receive/Transmit Buffer Descriptor (RxBD)
The switch buffer structure consists of a BD table that points to data buffers. The RxBDs contain, apart
from the buffer pointer, the packet header, as shown in Figure 32-19. The buffers contain the packet
payload. This BD is common to the receiver and the transmitter.
Table 3-11 describes the Switch RxBD fields.
0 7 8 11 12 13 14 15
Offset + 0x00 TX CID — RBM PPD SubType
Offset + 0x02 TxQD Pointer
Figure 32-18. CPS Switch Rx Queue Descriptor
Table 32-9. CPS Switch RxQD Field Descriptions
Offset Bits Name
1
1
Boldfaced entries must be initialized by the user.
Description
0x00 0-7 TX CID Translation CID. The received CID is saved in a TX Queue with this new CID number.
8-11 — Reserved, should be cleared during initialization.
12 RBM Receive buffer mask
0 Disable receive buffer interrupt
1 Enable receive buffer interrupt
13 PPD Partial packet discard
0 Normal mode
1 When a buffer-not-ready event causes a packet to be discarded, the remainder of the
SSSAR SDU is also discarded. This allows for better performance for switched
channels that implement SSSAR.
14-15 SubType Sublayer type. Should be 01 (CPS switched) for this descriptor.
00 CPS sublayer
01 CPS switched
10 SSSAR
11 Reserved
0x02 — TxQD
Pointer
Points to the TxQD into which the packets of this CID are stored and later sent.
0 1 2 3 4 5 6 7 8 15
Offset + 0x00 E/R 0 W I — UP CPS Packet Header
Offset + 0x02 Packet Header (Receiver CC)
Offset + 0x04 Rx Data Buffer Pointer (RXDBPTR)
Offset + 0x06
Figure 32-19. Switch Receive/Transmit Buffer Descriptor