User's Manual

TM
External Use 12
FCC compliance information
• This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
• Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
• Please notice that if the FCC identification number is not visible when the module is installed inside
another device, then the outside of the device into which the module is installed must also display a label
referring to the enclosed module. This exterior label can use wording such as the following: “Contains FCC
ID RUN-FRDM-KW24D512” any similar wording that expresses the same meaning may be used.
• This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with a minimum distance of 20cm between the radiator & your
body. This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
• The board is a reference/evaluation platform that can be programmed in different ways by developers to
implement and evaluate wireless functionality. The test firmware is pre-loaded in the board during
production, and the “connectivity test” firmware allows the radio to be put into different TX and RX modes
and to run PER tests. The RF section is a 2.4 GHz 802.15.4 compliant radio with a fixed printed “F”
antenna. The board only requires +5V power to operate without any need for special installation.