User's Manual

MC33493MODxxx Quick Start Guide
Laurent GAUTHIER-TSPG-MCD-ARC Page 2
Available script files:
 standby configuration
 continuous CW transmission
 continuous 4.8kHz OOK transmission
 continuous 4.8kHz FSK transmission
2 LAUNCHING THE KIT
 Plug the RF Module on the MCU board
 Connect the MCU board to the PC using the RS232 cable
 Launch HyperTerminal using the proper xxx.ht file according to available COM port
 Connect the 9V battery
 Screen on HyperTerminal receives status of MC33493 Registers and Pin levels
3 SENDING A SCRIPT FILE
3.1 Configuration in Receive mode
 With the mouse, click on “Transfer/Send text file”
 Select the xxx.txt Script file corresponding to the wanted configuration
 For exemple :“TX OOK 433.92MHz Square 4800bps.txt” will configure the kit in Teceive mode at
433.92MHz to send a modulated signal at 4800bps.
 At the end: “Sending square wave” indicates that the kit is sending a continuous modulation