User's Manual

MC33696MODxxx Quick Start Guide
Laurent GAUTHIER-TSPG-MCD-ARC Page 2
Available script files:
 standby configuration
 continuous CW transmission
 continuous 4.8kHz OOK transmission
 continuous 4.8kHz FSK transmission
 1 frame transmission using ID and HD
 1 frame reception using ID and HD
2 LAUNCHING THE KIT
 Plug the RF Module on the MCU board
 Connect the MCU board to the PC using the RS232 cable
 Launch HyperTerminal using the proper xxx.ht file according to available COM port
 Connect the 9V battery
 Screen on HyperTerminal receives status of MC33696 Registers and Pin levels
3 SENDING A SCRIPT FILE
3.1 Configuration in Receive mode
 With the mouse, click on “Transfer/Send text file”
 Select the xxx.txt Script file corresponding to the wanted configuration
 For exemple :“RX OOK 433.92MHz IDHD00.txt” will configure the kit in receive mode at 433.92MHz
to receive any Square modulated signal at 4800bps :
 433.92MHz, OOK
 Receive with Data Manager
 ID=00h, ID length=2 bits
 HD=00h, HD length=1 bit