User's Guide
Table Of Contents
- 1 Package Contents
- 2 Introduction to the Interface
- 3 Connecting and Configuring the MPC8377EWLAN Wireless Router
- 3.1 Connecting the MPC8377EWLAN Wireless Router (Wired Computing)
- 3.2 Connecting the MPC8377EWLAN Wireless Router (Wireless Computing)
- 3.3 Setting Up the IP Address
- 3.4 Configuring the MCP8377EWLAN Wireless Router
- 3.5 Changing the Operation Mode
- 3.6 Selecting DynDNS Settings
- 3.7 Firewalls
- 4 Selecting or Changing System Items
- 5 Status
- 6 VPN
- 7 Managing Storage, Samba, and File Editing in NAS
- 8 Intrusion Detection Systems
- 9 Intrusion Prevention Systems
- 10 Logout
MPC8377EWLAN Wireless Router SW User’s Guide 10
a configuration terminal. Verify the TCP/IP settings. Normally, the TCP/IP setting should be on the IP
subnet of the MPC8377EWLAN wireless router.
NOTE
Before you start, you should use a wired connection for initial
configuration, which will avoid possible setup problem due to
wireless uncertainty.
3.1 Connecting the MPC8377EWLAN Wireless Router (Wired
Computing)
This section explains the wiring setup for the computer connected to the Internet. The MPC8377EWLAN
wireless router has the capability to support usage of power adapter (48 V power supply) and POE (Power
over Ethernet).
3.1.1 Using the Power Adapter
There must be at least two RJ-45 cables in the MPC8377EWLAN wireless router wiring connection while
using a power adapter. Table 3-1 lists the cable connections, and Figure 3-1 depicts them below.
Table 3-1. Cable Connections, Power Adapter
Cable
Cable # From To
1 Router, WAN port ADSL or computer modem, Ethernet
2 Router, LAN port Your computer port
Figure 3-1. Cable Connection Layout, Power Adapter