User's Guide
Table Of Contents
- 1 Package Contents
- 2 Introduction to the Interface
- 3 Connecting and Configuring the MPC8377EWLAN Wireless Router
- 3.1 Connecting the MPC8377EWLAN Wireless Router (Wired Computing)
- 3.2 Connecting the MPC8377EWLAN Wireless Router (Wireless Computing)
- 3.3 Setting Up the IP Address
- 3.4 Configuring the MCP8377EWLAN Wireless Router
- 3.5 Changing the Operation Mode
- 3.6 Selecting DynDNS Settings
- 3.7 Firewalls
- 4 Selecting or Changing System Items
- 5 Status
- 6 VPN
- 7 Managing Storage, Samba, and File Editing in NAS
- 8 Intrusion Detection Systems
- 9 Intrusion Prevention Systems
- 10 Logout
MPC8377EWLAN Wireless Router SW User’s Guide 37
Table 3-4 Port Forwarding
Options Description
Name Enter the name of the port.
Protocol Select the protocol used for this application from
the drop-down list. You can select TCP, UDP or
Both as a protocol.
Source IP Enter the source IP.
Destination IP Enter the destination IP.
To IP Address Enter the IP address.
Port Enter the port address.
Remove Rule Click this link to remove the rule.
Click Save Changes to apply your changes.
4 Selecting or Changing System Items
This section explains selecting or changing system items as follows: Settings, Password, Firmware
Upgrade, and Reboot. Click System (Figure 4-1), then proceed with the respective sections.
Figure 4-1. System
4.1 Settings
Click Settings. Figure 4-2 depicts the System > Settings window. Type the host name and select your
time zone or closest region.