User's Guide
Table Of Contents
- 1 Package Contents
- 2 Introduction to the Interface
- 3 Connecting and Configuring the MPC8377EWLAN Wireless Router
- 3.1 Connecting the MPC8377EWLAN Wireless Router (Wired Computing)
- 3.2 Connecting the MPC8377EWLAN Wireless Router (Wireless Computing)
- 3.3 Setting Up the IP Address
- 3.4 Configuring the MCP8377EWLAN Wireless Router
- 3.5 Changing the Operation Mode
- 3.6 Selecting DynDNS Settings
- 3.7 Firewalls
- 4 Selecting or Changing System Items
- 5 Status
- 6 VPN
- 7 Managing Storage, Samba, and File Editing in NAS
- 8 Intrusion Detection Systems
- 9 Intrusion Prevention Systems
- 10 Logout
MPC8377EWLAN Wireless Router SW User’s Guide 40
device at this port.
4.4 Firmware Upgrade
Click Upgrade. Figure 4-5 depicts the System > Firmware Upgrade window. Click Browse to locate
the new firmware, then click Upgrade to change the firmware.
NOTE
Upgrading firmware may take a few minutes. Do not turn off the
power nor invoke any resets, such as pressing the reset button).
Figure 4-5. Firmware Upgrade
Click Save Changes, if certain. (There are also the following options: Apply Changes, Clear Changes,
Review Changes.)
4.5 Reboot
Click Reboot. Figure 4-6 depicts the System > Reboot window. Click Yes, really reboot now button to
reboot the router.
Figure 4-6. Reboot
5 Status
This section explains viewing the unit’s status. Click Status (Figure 4-1), then proceed with the
respective sections.
Figure 5-1. System