User's Guide
Table Of Contents
- 1 Package Contents
- 2 Introduction to the Interface
- 3 Connecting and Configuring the MPC8377EWLAN Wireless Router
- 3.1 Connecting the MPC8377EWLAN Wireless Router (Wired Computing)
- 3.2 Connecting the MPC8377EWLAN Wireless Router (Wireless Computing)
- 3.3 Setting Up the IP Address
- 3.4 Configuring the MCP8377EWLAN Wireless Router
- 3.5 Changing the Operation Mode
- 3.6 Selecting DynDNS Settings
- 3.7 Firewalls
- 4 Selecting or Changing System Items
- 5 Status
- 6 VPN
- 7 Managing Storage, Samba, and File Editing in NAS
- 8 Intrusion Detection Systems
- 9 Intrusion Prevention Systems
- 10 Logout
MPC8377EWLAN Wireless Router SW User’s Guide 51
Local IP Enter the Local IP address.
Local Mask Enter the mask to determine the IP addresses on the
local network.
Peer IP Enter the peer IP address of tunnel.
Remote Security Gateway Type Select IP only or IP + domain from the Remote
Security Gateway Type drop-down list. Incase, you
select IP Only, then only the specific IP Address will
be able to access the tunnel.
Destination IP Enter the destination IP address.
Destination Mask Enter the mask to determine the IP addresses on the
Destination network.
Keying Mode Select the keying mode from the Keying Mode drop-
down list. You can select Manual or Preshared Key
mode. See section 6.1.1 Keying Mode for details.
6.1.1 Keying Mode – IKE Config
The router supports both IKE with Preshared Key (automatic) and Manual key management. When
choosing automatic key management, IKE (Internet Key Exchange) protocols are used to negotiate key
material for SA. If manual key management is selected, no key negotiation is needed. The manual key
management is used for small static environments or for troubleshooting purpose. Notice that both sides
must use the same Key Management method.
6.1.1.1 IKE with Preshared Key
Select IKE with preshared key from Keying mode drop-down list. The options changes in the
application page as shown in Figure 6-2 below: