User's Guide
Table Of Contents
- 1 Package Contents
- 2 Introduction to the Interface
- 3 Connecting and Configuring the MPC8377EWLAN Wireless Router
- 3.1 Connecting the MPC8377EWLAN Wireless Router (Wired Computing)
- 3.2 Connecting the MPC8377EWLAN Wireless Router (Wireless Computing)
- 3.3 Setting Up the IP Address
- 3.4 Configuring the MCP8377EWLAN Wireless Router
- 3.5 Changing the Operation Mode
- 3.6 Selecting DynDNS Settings
- 3.7 Firewalls
- 4 Selecting or Changing System Items
- 5 Status
- 6 VPN
- 7 Managing Storage, Samba, and File Editing in NAS
- 8 Intrusion Detection Systems
- 9 Intrusion Prevention Systems
- 10 Logout
MPC8377EWLAN Wireless Router SW User’s Guide 59
File system These are the entire file systems (FS) supported. “Other”
represents other file systems
Mount point This is the mount point of this RAID device.
Action Command Caution: If you choose Create/Format, then all data is
deleted from the disk.
Figure 7-8. Add New RAID
NOTE
Before using RAID management, make sure that you have selected
RAID in the File system drop-down list (Figure 7-9).
Figure 7-9. RAID File System Selection
7.3.1 Create RAID0
This procedure creates the software RAID0. Perform the following steps, as depicted in Figure 7-10: