User's Guide
Table Of Contents
- 1 Package Contents
- 2 Introduction to the Interface
- 3 Connecting and Configuring the MPC8377EWLAN Wireless Router
- 3.1 Connecting the MPC8377EWLAN Wireless Router (Wired Computing)
- 3.2 Connecting the MPC8377EWLAN Wireless Router (Wireless Computing)
- 3.3 Setting Up the IP Address
- 3.4 Configuring the MCP8377EWLAN Wireless Router
- 3.5 Changing the Operation Mode
- 3.6 Selecting DynDNS Settings
- 3.7 Firewalls
- 4 Selecting or Changing System Items
- 5 Status
- 6 VPN
- 7 Managing Storage, Samba, and File Editing in NAS
- 8 Intrusion Detection Systems
- 9 Intrusion Prevention Systems
- 10 Logout
MPC8377EWLAN Wireless Router SW User’s Guide 62
7.3.4 Recovery
If one disk is out of service, and a new disk is added or any other reason that makes the state of RAID
abnormal, you can choose this command to recover the RAID. Perform the following steps as depicted in
Figure 7-13:
1. From the Raid devices drop-down list, select the device.
2. From the Action Command drop-down list, select Recover.
Figure 7-13. RAID Recovery
7.3.5 Mount
To mount the RAID to one folder, such as /home, perform the following steps as shown in Figure 7-14:
1. In the Mount point field, type the address you want to mount. For example, /home.
2. From the Action Command drop-down list, select Mount.