User Manual
Table Of Contents
- 1 Introduction
- 2 Features
- 3 Transceiver description
- 4 System and power management
- 5 Radio Peripherals
- 6 MKW2xDxxxV operating modes
- 7 MKW2xDxxxV electrical characteristics
- 8 MCU Electrical characteristics
- 8.1 Maximum ratings
- 8.2 General
- 8.3 LVD and POR operating requirements
- 8.4 Switching specification
- 8.5 Core modules
- 8.6 Clock modules
- 8.7 Memories and memory interfaces
- 8.8 Analog
- 8.9 Communication interfaces
- 8.9.1 USB electrical specifications
- 8.9.2 USB DCD electrical specifications
- 8.9.3 VREG electrical specifications
- 8.9.4 DSPI switching specifications (limited voltate range)
- 8.9.5 DSPI switching specification (full voltage range)
- 8.9.6 Normal Run, Wait and Stop mode performance over the fulloperating voltage range
- 8.9.7 VLPR, VLPW, and VLPS mode performance over the full operating voltage range
- 9 Transceiver electrical characteristics
- 10 Crystal oscillator reference frequency
- 11 Pin assignments
- 12 Packaging information
MKW2xDxxxV Product Electrical Specification, Rev. 0.1
16 Freescale Semiconductor
• Doze (low power with reference oscillator active)
• Idle
• Receive
• Transmit
Table 5 lists and describes these modes.
The MCU has these radio modes:
Table 6. MCU power modes
Table 5. Radio mode definitions and transition times
Mode Definition
Current
consumption
1
1
Conditions: VBAT and VBAT_2 = 2.7 V, nominal process @ 25C
Transition time
to or from idle
Reset /
powerdown
All IC functions off, leakage only. RST asserted. < 30 nA TBD
Low power /
hibernate
Crystal reference oscillator off. (SPI is functional.) < 1 A TBD
Doze Crystal reference oscillator on but CLK_OUT output available only if
selected.
600 A
(no clockout)
TBD
Idle Crystal reference oscillator on with CLK_OUT output available. 700 A
(no clockout)
TBD
Receive Crystal reference oscillator on. Receiver on. 15 mA
2
2
Signal sensitivity = –102 dBm
TBD
Transmit Crystal reference oscillator on. Transmitter on. 15 mA
3
3
RF output = 0 dBm
TBD