User Manual
Table Of Contents
- 1 Introduction
- 2 Features
- 3 Transceiver description
- 4 System and power management
- 5 Radio Peripherals
- 6 MKW2xDxxxV operating modes
- 7 MKW2xDxxxV electrical characteristics
- 8 MCU Electrical characteristics
- 8.1 Maximum ratings
- 8.2 General
- 8.3 LVD and POR operating requirements
- 8.4 Switching specification
- 8.5 Core modules
- 8.6 Clock modules
- 8.7 Memories and memory interfaces
- 8.8 Analog
- 8.9 Communication interfaces
- 8.9.1 USB electrical specifications
- 8.9.2 USB DCD electrical specifications
- 8.9.3 VREG electrical specifications
- 8.9.4 DSPI switching specifications (limited voltate range)
- 8.9.5 DSPI switching specification (full voltage range)
- 8.9.6 Normal Run, Wait and Stop mode performance over the fulloperating voltage range
- 8.9.7 VLPR, VLPW, and VLPS mode performance over the full operating voltage range
- 9 Transceiver electrical characteristics
- 10 Crystal oscillator reference frequency
- 11 Pin assignments
- 12 Packaging information
MKW2xDxxxV Product Electrical Specification, Rev. 0.1
24 Freescale Semiconductor
8.2.2 Nonswitching electrical specifications
8.2.2.1 Voltage and current operating requirements
1
1. All analog pins are internally clamped to VSS and VDD through ESD protection diodes. If VIN is greater than VAIO_MIN
(=VSS-0.3V) and VIN is less than VAIO_MAX(=VDD+0.3V) is observed, then there is no need to provide current limiting resistors
at the pads. If these limits cannot be observed then a current limiting resistor is required. The negative DC injection current
limiting resistor is calculated as R=(VAIO_MIN-VIN)/|IIC|. The positive injection current limiting resistor is calcualted as
R=(V
IN-VAIO_MAX)/|IIC|. Select the larger of these two calculated resistances.